Skip Navigation Website Accessibility
  Unit 7, 89 Erindale Road, Balcatta, Perth, Western Australia, 6021
 


Hyperion Torch FL350

DESCRIPTION

The Hyperion 350 Dive Light is a great cray hunting or back up torch, punching out 350 Lumens of light which is more than twice that of similar more expensive models. When loaded with 4 x AA batteries (not included) the Hyperion FL350 will burn for 150 minutes (2.5 hours) and will accept rechargeable batteries as well. The switch on the torch is a magnetic slide switch with 3 modes (High - Low - Strobe) and comes with a unique O-ring system to stop the torch from being activated in your bag or BCD pocket. The torch is depth rated to 50 metres and measures 42 mm (D) x 160 mm (L). Lastly, the torch comes with two mounting options, a traditional wrist lanyard as well as a wrist strap system that with a little creativity can be used to mount straight onto the side of a cray snare or speargun.


TECHNICAL FEATURES

  • Hand Held, Compact and Rugged Dive Light
  • Great for Cray Bashing or as a Backup Light
  • Designed to Use as Primary or Backup Dive Light
  • Bright 350 Lumen LED Dive Torch
  • Long Two and a Half Hour Burn Time
  • High, Low and SOS Strobe Modes
  • Powered by Four AA Batteries (not included)
  • Simple to Use Magnetc Switch
  • Versatilke Wrist Lanyard

LIGHT SPECIFICATIONS

  • Three Modes: High, Low, Strobe
  • Lumens: 350
  • Depth: 50 metres
  • Switch: Magnetic
  • Batteries: 4 x AA Alkaline (not included)
  • Run Time: approx. 150 minutes
  • Size: 42 mm (D) x 160 mm (L)
  • Warranty: 1 year

INSTRUCTIONS
  • Slide the switch to activate the light and cylcle through the power levels.
  • Slide and hold the switch for 6 seconds to activate SOS Light Mode.

MAINTENANCE AND CARE
  • The torch should be rinsed thorouly with fresh water after every use.
  • Check the O-rings to make sure they are clean every time the tirch is opened.
  • Remove any dirt/debris from the O-ring to ensure the torch does not leak.
  • The O-rings should be checked periodically for cracks and damage, and replaced if damaged.
  • Lubricate O-rings with silicone grease.
  • Do not attempt to open or disassemble any part of this light. Disassemble will void warranty.